Uncategorized admin  

Gauging Ears With Stretched Piercings

Stretch piercings in your ear lobes can be obtained by gauging ears to a specific piercing size, either in one go or by means of several successive earlobe stretchings. A lot depends on how large you want your piercing to be, and anything that one gauge more than the last will involve more than one stretching.

Gauging ears is carried out using ‘gauge numbers’ that refer to a specific diameter of hole. For example, gauge 20 is written as 20g, and that refers to a piercing of 0.8 mm in diameter. 18g refers to a piercing of 1 mm in diameter, so as the gauge numbers drop then the diameter increases. Also, gauges drop in twos, so that there are no odd gauge numbers. Thus, the sequence goes: 20g, 18g, 16g, 14g and so on to 00g. Therefore one gauge step down is from one even number to the next and from a lower piercing diameter to a higher.

When gauging ears you should stretch piercings by only one gauge step. So, if you want to change from 16g to 14 g (1.2 mm to 1.6 mm) you can do so in one step. However, if you wanted to go from a 16g to an 8g (1.2 mm to 3.2 mm) you would have to do that in four steps, involving four stretched piercings, each of one gauge level.

When you have your earlobes pierced with the intention of increasing the gauging to a fairly high diameter for some gorgeous large-diameter bars you have seen or even a cool flesh tunnel, then first consider the initial diameter – the greater the initial diameter then the fewer ear lobe stretching steps you will have to undergo to reach your preferred diameter. Do not have your ears pierced in a shopping mall with a gun because these generally pierce at 20g or 18g at the most.

 

 

Leave A Comment